Homemade Diy Free Standing Pull Up Bar

It is made from 2x4s 2x6s plywood and some iron pipe fittings.

Homemade diy free standing pull up bar.

The 90 degree elbow is used in places where the structure changes direction in a 90 degree turn. These are dependent on the height of your garage ceiling and how you want to set up your pull up bar. 8 wood screws i got one pack of 14 screws and two packs of 12 screws nine total. Materials to build a diy pull up bar.

Only do this if you know how to embed beefy drywall anchors. 2 1 inch floor flanges. Insert one 90 degree elbow into each end of the long bar. The 90 degree elbow the 30 to 60 degree single socket tee and the three socket tee.

The free standing pull up bar design utilizes just three different kee klamp fittings. Fittings used to build the pull up bar. Ryobi nation diy pull up bar this diy pull up bar doesn t need a doorway and can serve as a work out station for additional exercises. 2 4 6 12 foot posts use treated lumber 1 4 foot 1 inch threaded pipe.

Use your wrench to tighten as needed. 1 tube of loctite threadlocker. I was very carful to make sure that the structure was securely fastened to the wall to avoid injury. How to build a pull up bar.

Measure 3 inches from the bottom of the boards and use the 1 1 2 inch spade bit to make a hole in both boards. This example is cut to 18 inches but it will vary depending on ceiling height and personal preference. If you face your drywall with wood and anchor it well up the wall it will provide a solid base for making a diy pull up bar at home.